Page 1 of 1

Parts Wanted

Posted: Sun Sep 16, 2018 10:01 am
by Jim Mountain
Hi all, I'm after a few bits to finish off my 4/4.

A couple of factory door mirrors.

1 X bonnet catch, I had 4, but seem to have mislaid one!

A set of alloy, center lock wheels (5 or 6), 6" X 15", a set of revolutions would be nice.

Hood frame to fit a 70's 4/4, any condition as I'm going to cut it up.

Cheers Jim

Re: Parts Wanted

Posted: Tue Sep 25, 2018 8:45 am
by Merlyn1000
Hi Jim, if you're after 15" peg drive centre locks I have some. They are the revolution style but probably wider than you need. Easy to change rim width though...

Re: Parts Wanted

Posted: Wed Oct 03, 2018 2:27 pm
by Richard Smith
I have a hood frame...seems pretty decent, I am in N E Derbys...

Re: Parts Wanted

Posted: Tue Oct 09, 2018 5:23 pm
by Jim Mountain
Merlyn1000 wrote:Hi Jim, if you're after 15" peg drive centre locks I have some. They are the revolution style but probably wider than you need. Easy to change rim width though...
Thanks, but was after spline drive, so I can keep the wires with a different set of tyres.

Cheers Jim

Re: Parts Wanted

Posted: Tue Oct 09, 2018 5:26 pm
by Jim Mountain
Richard Smith wrote:I have a hood frame...seems pretty decent, I am in N E Derbys...
Hi Richard, wish I'd seen this before the weekend I drove through Derby, on the way back from the Edinburgh trial at the weekend.

How much do you want for it?

Would you hold on to it until I'm up your way again?possibly before Christmas.

Re: Parts Wanted

Posted: Tue Oct 09, 2018 5:29 pm
by Richard Smith
Yep, no problems hanging on to it Jim....

Money? beer or whisky!

cheers