re-sealing tubeless wires
- Richard Smith
- Posts: 483
- Joined: Sun May 15, 2005 3:45 pm
- Location: Unstone Green, Derbyshire
- Contact:
re-sealing tubeless wires
Any ideas where to go to get this done? When my wires were refurbed, the tubeless facility was removed, and I would prefer to have them 're-tubelessed' rather than have tubeless tyres with tubes.
Richard Smith
Unstone Green, Derbyshire
1993 4/4 1.6efi MSCC 11823
Unstone Green, Derbyshire
1993 4/4 1.6efi MSCC 11823
- Philip Tisdall
- Posts: 411
- Joined: Thu Dec 15, 2005 6:10 pm
- Location: Warwickshire
Re: re-sealing tubeless wires
Richard,
You can do this yourself. Go and get a GOOD Silison sealent, clean off the area where the "spokes" go through and spread a good layer across the area. I made a template scraper and put about 1/4 inch thick. I also used a larhe wooden dowel to rotate the wheel when applying the sealent. I think I used about 2 tubes per wheel.
Works well and it is what they isue on new wire wheels now.
You can do this yourself. Go and get a GOOD Silison sealent, clean off the area where the "spokes" go through and spread a good layer across the area. I made a template scraper and put about 1/4 inch thick. I also used a larhe wooden dowel to rotate the wheel when applying the sealent. I think I used about 2 tubes per wheel.
Works well and it is what they isue on new wire wheels now.
Philip
- Richard Smith
- Posts: 483
- Joined: Sun May 15, 2005 3:45 pm
- Location: Unstone Green, Derbyshire
- Contact:
Re: re-sealing tubeless wires
Thanks Philip, I am about to take my punctured wheel to the local tyre place, and will see exactly what's on the rim. I have spoken to MWS, and they say it could cost £50 per rim to re-seal!
Richard Smith
Unstone Green, Derbyshire
1993 4/4 1.6efi MSCC 11823
Unstone Green, Derbyshire
1993 4/4 1.6efi MSCC 11823